Voir Les Détails sur eBay

Seachem Phosguard Phosphate Silicate Remover Filter Media Aquarium

EUR 10,57 Achat immédiat 14h, EUR 9,81 Livraison, 60-Day Retours, Garantie client eBay: En cas de problème, vous êtes remboursé!

Vendeur: millpets (148.452) 99.6%, Lieu où se trouve: Chesterfield, Lieu de livraison: GB et de nombreux autres pays, Numéro de l'objet: 282269733934 Seachem PhosGuardPhosGuard rapidly removes phosphate and silicate from marine and freshwater aquaria. It is not recommended for phosphate buffered freshwater. PhosGuard is highly porous for high capacity and bead-shaped for optimum water flow.Aluminum Oxide, Soluble Aluminum, & Coral ToxicityRemoves silicate and phosphate Spherical for optimal hydrodynamics Irreversible binding In recent years, there has been speculation that aluminum oxide based phosphate removers like PhosGuard release aluminum into the water and subsequently damage corals. The evidence to support this claim was largely anecdotal.So, through a series of controlled experiments in both freshwater and saltwater, we intended to address both the question of aluminum solubility and aluminum toxicity. The results of these experiments show that under reef conditions (pH near 8) there is no detectable soluble aluminum released from alumina. Under conditions of low pH and high dosage levels, soluble aluminum can be released from alumina; at three times the label dosage rate, we detected 0.2 mg/L aluminum at a pH of 5.3.Additionally, aluminum oxide is not easily absorbed into the cell to cause negative reactions. Even at three times the dose of PhosGuard, soft-bodied corals such as Sarcophyton remain unaffected.DirectionsMay generate heat on initial contact with water. Pre-wet by adding to a double volume of freshwater, followed by a rinse. For best results, PhosGuard should be rinsed before use and placed so as to maximize the flow of water through it but not so that it tumbles against itself in flow. It may be used in a canister filter, media chamber, box filter, or any high flow area of a trickle filter. Use of a filter bag is recommended. Use 85 mL (1/3 cup) for every 200 L (50 US gallons) saltwater or 400 L (100 US gallons) freshwater.Leave product in place for 4 days, then test phosphate or silicate concentrations with either MultiTest: Phosphate or MultiTest: Silicate. If the concentration of the component you are trying to decrease has not dropped to around 0.02 mg/L, then replace the PhosGuard, otherwise leave in place until levels begin to climb again. As long as concentrations remain under control, the product is not exhausted. Over treating is not recommended. PhosGuard is not an exchange resin and does not release anything into the water. It does not leach phosphate or silicate back into the water and may be removed, dried, and returned to service until exhausted. Continuous use of small quantities is better than intermittent use of larger quantities. Brand: Seachem, Type: Phosphate & Silicate Remover, Test/Treatment Parameter: Phosphate, Water Type: All Water Types

PicClick Insights PicClick Exclusif

  •  Popularité - 409 Vues, 4 Suivi, Super grande quantité sur vues. Bonne quantité suivi. Très grande quantité vendu, 15 Vendu, 15 Disponibles.
  •  Prix -
  •  Vendeur - Plus de 148.452 articles vendu. 0.4% évaluations négative. Grand vendeur avec la très bonne rétroaction positive et plus de 50 cotes.

Les Gens ont Aussi Aimé