Vendeur: seahorse-breeder (2.914) 100%, Lieu où se trouve: Shrewsbury, Lieu de livraison: Europe, Numéro de l'objet: 322309589920 Brand: Seahorse Breeder, MPN: Does Not Apply, Les Détails: Nitrate filter / reactor including seachem denigrate media systems up to 100 litresThis filter comes complete with all the equipment you need to start to reduce the nitrates in your system. Suitable for systems up to 100 Litres These units measure approximately 6cms wide x 7cms deep including bracket x 30cms high. Product Description:These units must be installed vertically using the bracket provided. The denitrate kit comes with the following: • Filter housing• Mounting bracket• Fittings including control valve• 2x 1-meter lengths of 4mm silicone tube• 250ml Seachem denitrate™ media denitrate™ is an economical, natural, porous material with a pore distribution and geometry that promotes both aerobic nitrification within the first few millimeters of depth and anaerobic denitrification at the core. The material has a high surface area and supports a high density of bacteria. Although de nitrate™ has capacity to trap nitrate, this, as with other nitrate retaining materials, such as certain zeolites and synthetic resins, is quite limited and the primary mechanism of nitrate removal is anaerobic. Why It's Different:“Live” rocks or reef rocks remove nitrate by anaerobic denitrification. De nitrate™ removes nitrate by the same process. Efficiency is magnified several folds by forcing the water to filter through the porous de nitrate™. As with reef rock, anaerobic conditions are achieved by the porosity and the depletion of oxygen by the aerobic process at the surface. Excessive flow rates should, therefore, be avoided, as they may impede development of an adequate anaerobic environment to support denitrifying bacteria. De nitrate™ is also an excellent media for aerobic nitrification and it makes an ideal biological filter in drip trays, canister filters, sumps, or even box filters. At high flow rates (greater than 100 US gallons per hour), it will function solely as an aerobic filter. At slow flow rates (less than 50 US gallons per hour), it will function as both an aerobic filter and an anaerobic denitrifying filter. Directions:For best results, de*nitrate™ should be placed to assure the flow of water through it, such as in a canister filter, chemical filtration module, or box filter. Flow rate should not exceed 200 L (50 gallons*) per hour. If higher flow rates are unavoidable, use Matrix™ or Pond Matrix™. It is best to rinse off dust before use. Once de*nitrate™ has been in use for several days, nitrate concentrations should start to fall and level off gradually at a concentration of about 4–5 mg/L as nitrate. As long as nitrate concentrations remain under control, the product is not exhausted. Each 500 mL of de*nitrate™ treats about 100–200 L (25–50 gallons*), depending on initial nitrate concentration and the current biological load. Enough should be used to remove nitrate at a rate at least as fast as the rate of formation. If very high nitrates are initially present, they should be brought down to less than 20 mg/L with water changes.